Best Of
Re: Another glitch on a steam install
yes and yes. It seems like if I goof something up, the demons and vipers are biting at my heels. But when somebody else does a goofy job, everything works out just fine.
GW
Re: Ladder standoffs for roofs
This one
is almost identical to the one I have and am very happy with.
Re: Another glitch on a steam install
"works" can have a lot of meanings. I wonder how close the output of that boiler is to the actual connected edr
mattmia2
Re: Laars MFTCW 199 Harmonic Noise
Combustion is most likely out of tune and needs to be adjusted using a combustion analyzer. It could also be several other things like CSST piping, low gas pressure, undersized regulator, plugged intake, etc but this is a pretty common symptom of a boiler that was not properly commissioned. Being a Mascot that's cheap online, would it be safe to assume that this was not professionally installed and commissioned?
GroundUp
Re: short cycling on combi boiler.
Did this always happen or is it new? The flow sensor can get fouled and cause this sort of problem.
mattmia2
Re: Another glitch on a steam install
It’s also piped wrong with the main tapped between the risers.
Ironman
Re: Utica Combi Boiler (MAC-150)-Error 133- Causing big bang noise after few trial of combustion
I would definitely check the vent pipe and air intake. Tuning it with a digital combustion analyzer is crucial. These things are not good to go out of the box. Professional installation and maintenance are needed for reliable operation.
Re: Thoughts on brass bushings and plugs
it’s your system do as you like!
You ask for advice but choose to ignore it.
pecmsg
Re: Utica Combi Boiler (MAC-150)-Error 133- Causing big bang noise after few trial of combustion
Yes, its scary. Which is why there are qualified people in the trade to make sure your extremities stay attached to the rest of you. A few years is 3,4? Has it ever been serviced? Has it ever met a combustion analyzer?
HVACNUT