Best Of
Re: Energy Kinetics System 2000 Heat Exchanger
Thank you for your post, @RJHNY1 .
For reference, HeatingHelp does not allow prices, so that will probably be removed if you do not remove it.
From this page, we show that trade list price of the plate heat exchanger. It is unusual (but not unheard of) that a heat exchanger would fail in the way you describe (it could also be a bad expansion tank that allows the system to over pressurize). The photo does look like it might be dripping out of the side of the heat exchanger, in which case it needs to be replaced. That type of failure is from corrosion and our plate heat exchangers for several years now have a non-stick coating that prevents most mineral build up and is also very corrosion resistant, so it should last a very long time. If it corroded from the domestic water side, you should have your water checked, and if it corroded from the boiler side, it should probably be flushed and have an additive like 8-Way that increases the pH and prevents hydronic side corrosion.
The best way for me to help is to have you reach out to your territory manager, John Hachmann, who knows all the dealers in your area. He can be reached at (516) 459-1701 or jhachmann@energykinetics.com .
Please also feel free to reach out to our customer service team at (908) 735-2066 or reply again to the PMs that we've exchanged.
Best,
Roger
Roger
Re: I'm getting solar panels. I'll let you know how it goes in this discussion thread.
Pretty house, like your flower boxes. Keeping the upper level window boxes water have proven to be a challenge for us. 😉
PC7060
Re: I'm getting solar panels. I'll let you know how it goes in this discussion thread.
installation hasn’t happened yet. They have been out once so far to look at the support structure of the house frame.
During the quote process I sent them photos of the attic and the floor plans.
Since this roof supported 2 layers of shingles for about 30 years and now has one layer, and since it’s built with old growth pine with old, larger dimensions that is very strong I personally am not worried about it.
Panels weigh like 3 pounds per sq ft. My understanding is that roofs are expected to be able to carry 20 pounds per sq ft of snow without stress.
Re: I'm getting solar panels. I'll let you know how it goes in this discussion thread.
amateur radio off-center fed dipole
Re: Cold Radiator
That section of horizontal riser on the top floor most likely is the trap . The radiator need to be lifted to regain the pitch in that section . Someone pulled the radiator to finish the radiator nook and left the shims out .
Hope this helps
Big Ed_4
Re: I'm getting solar panels. I'll let you know how it goes in this discussion thread.
guess we don’t live in HOAs 😂
Re: I'm getting solar panels. I'll let you know how it goes in this discussion thread.
that’s it! All installed in one day, pretty good! It won’t start operating until it clears inspections. And since my boiler, water heater, and panel upgrade, all performed by me passed, I have a feeling this professional job is gonna be fine.
without talking prices, this is about the same as a high quality steam boiler install in NJ
