Best Of
Re: Electric Anode rods
Hi and yes, @mattmia2 . But it's sort of a bean-counter's guess. How can the manufacturer know in anything other than a very general way what water the heater will see? Powered rods cost more, but might be a better one-size-fits-all solution. 😎
Yours, Larry
Re: Off grid heating/ac minisplit efficiency
Hi, My experience with off grid stuff has been clear that pure sine wave power is needed for electronics. Even modified sine wave is considered to be "dirty power" and makes electronics get all glitchy. Even LEDs have problems with anything but clean power.
Yours, Larry
Re: Steam Take-off piping
If you also put a drip back to the boiler return off the end of that extra header, it should be OK. Otherwise you may have problems. But why? Surely it might have been possible to find a harder way to pipe that?
Re: Boiler
On the other hand, I see a lot of decades-old Burnham Series 2 boilers, including newer variations like the ES2 and the Series 3……….
Re: Is the circulator pump too powerful?
The Taco pump for the 3rd floor has an internal flow check which is stuck open or has some debris in it. It’s in (or should be) the discharge side of the pump. Fix that and your problem will be resolved.
Ironman
Re: What was the best MacGuyver moment you actually saw on a job site?
EBE-Bratt : The boss was furious because...."No good deed goes unpunished! " Mad Dog
Re: do you really need a thermal expansion tank
If there is any form of check or non-return valve on that domestic system, then yes you need an expansion tank on the hot water, unless there is a well pressure tank AFTER the check or non-return valve.
Don't debate the issue — just do it.
Re: do you really need a thermal expansion tank
Hi, I'm thinking it's more of a "what if" or "worst case" scenario. Ed is right than essentially nobody checks the T&P yearly, and that could be a big liability to take on. But, the more obvious problem usually is thermal expansion. Water just gets bigger as it's heated. Where will that extra water go?
Yours, Larry
Re: Is the circulator pump too powerful?
With a cost recovery time of…. (a lot of years). Wait until they die, then upgrade. Oil the 100's annually, and you'll be in for a long wait.
Re: 100 year old radiator??
Wow!
What a beast! Is that a 4' level on it?
Looks like it would heat a whole house


