Best Of
Re: Mystery tool
I've looked at some pics of bed bolt installation on professional woodworking sites. If the nut mortise has a flat surface where the nut sits, the nut is typically installed with the rounded corners facing towards the end of the bolt, as shown in the Whitechapel pic above. If the nut mortise has a curved surface where the nut sits (if the mortise is drilled out with a round Forstner bit), the nut is installed with the rounded corners facing into the curve of the of the round mortise hole. So it can go either way depending on how you cut the mortise.
jesmed1
Re: Mystery tool
I saw one set of bunk beds with exactly the same bolts that @Larry Weingarten posted. Only one I ever saw and it wasn't an old bed.
Re: Literature on Geothermal
looking to stay 40+ deep into the season by alternating loops.
skyking1
Re: Mystery tool
Even now they can't do a lot more than watch a big fire if they don't have a municipal supply to pump from.
mattmia2
Re: Old fridge
LOL, I was wrong - it's not a post war fridge like I always thought it was. Curiosity got the better of me so I pulled it out and looked behind it - the model is B6-39-A, so it's over 85 years of continuous operation.
I'm selling my commercial building this summer where it's at - do these have any value or should I just leave it with the buyer? It needs to be stripped and painted and it needs a new gasket, but otherwise it's ice cold and dead quiet.
MaxMercy
Re: Stealing Steam Boiler Water for Hydronic Baseboard?
Well, technically you are correct on a leaking pump seal — or for that matter any leak on the pumped loop — emptying the boiler. That's one of the reasons, among many, for having a LWCO. The Hartford Loop, however, still protects the boiler against a leaking wet return, and since that is by far the most common sources of leaks in a steam system, why not have it?
You could, in principle, have a hot water radiator fed that way on the first floor. There are several ways to do it — the simplest being to have it up there and make sure it has no leaks, so that once it is purged a standard circulator can circulate it. However, a standard circulator likely will not be able to fill it if is allowed to empty for any reason. A higher head pump would work — provided there is enough head to avoid cavitation at the inlet. Another approach would be to use a heat exchanger and run a normal closed hydronic loop… more complicated.
Re: Mystery tool
Thanks everyone! Talk about crowd-sourced knowledge. Even better than AI!
So I'm going with "It's a bronze bed bolt wrench that can also be used safely on gas lines due to the inherent safety of non-sparking bronze, and can also be used on anything that happens to have a square-head bolt of 7/16", 1/2", or 5/8" size."
jesmed1
Re: Mystery tool
Meanwhile, here is an eBay listing for an old iron "bed wrench" marked "A L Firmin", which was a Boston cabinet company. As Firmin was a maker of cabinet hardware, not gas fittings or plumbing supplies, the bed wrench seems a more likely intended use.
jesmed1
Re: Mystery tool
Hi, I was curious to see what the bed bolts looked like that this wrench would fit, so did a search. Here's what I got. Looks like a good fit 😉
Yours, Larry
Re: Mystery tool
As a plumber I can say that the Whitechapel is a tee wrench and your wrench is a wye. So I am going to double down on it being a gas cock wrench and say it is very similar to the other wrench, but not the same. Bronze would be fairly expensive for a wrench to tighten bed frames.
