Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!
Best Of
Re: Demonstrating the PONMIPC...
My grandpa did it this way, and my dad did it this way, and by golly, I'm going to continue to do it this way. "Jeez, your family has been doing it WRONG for 3 generations! Congratulations!" Nothing like a family legacy :-)
ME
ME
Re: Looking for someone to walk me through an upgrade project.
House 3000 sq/ft
Out Building 2400 sq/ft
Out Building 2400 sq/ft
Re: Peerless Steamer in Progress
Up and running! Additionally job details: direct water heater with mixing valve/expansion tank (standard on all our installs), VXT, and (1) condensate zone.
Re: I NEED HELP! Choosing heating option for a triplex, hot water? forced air? steam?
@ChrisJ : Time for your funny tankless water heater video!
Re: PVC Venting on boilers again!
The fact, that label exists at all should tell you something. It's not a warning label about using PVC in a DWV system. Why would they produce that? Because they are manufacturing to ASTM standards, and those standards do not have the requirements for plastic pipe and fittings intended to vent flue gases.
With that disclaimer included on the label, I don't know how you can take comfort in the fact you followed manufacturers instructions and used it anyway? It's not an untruth, but the half-truth you're operating on is unacceptable.
With that disclaimer included on the label, I don't know how you can take comfort in the fact you followed manufacturers instructions and used it anyway? It's not an untruth, but the half-truth you're operating on is unacceptable.
Paul48
1
Re: oil tank vent whisle
i pour sludge clean down the vent pipe, if your lucky it will loosen up the crud in the whistle, its a fifty fifty shot and the sludge clean wont hurt your tank either
Re: why does it take so long to heat
@EBEBRATT-Ed No issue with the one pictured. It works ok and I see ones like this pretty often. It reminded of the one I found pumping into the boiler. It was......... different, lol. I was very surprised the house got through a winter like it was.
Flipped the pump around and it work fine.
Flipped the pump around and it work fine.
Re: Help with wiring of Profusion Heater and Aube relay w/ external thermostat
You can just leave the t-stat wired and turn the temp up.
The L2 you are wiring to the heater is hot as the heater is 240 volt. I believe you will need a separate neutral back to the panel to make the relay work correctly.
The L2 you are wiring to the heater is hot as the heater is 240 volt. I believe you will need a separate neutral back to the panel to make the relay work correctly.
Zman
0
IBC DC 20-125 Piping Diagram
I want to install a new high efficiency combi system, with 2 zones (one fin baseboard loop and one cast radiator loop). I chose this model which is oversized for my heating needs for the 3.2 DHW GPM. I have completely rebuilt this house from the studs on my own and want to finish the job with this system. Where could I locate a thorough piping diagram to insure a safe and effective installation?
