Best Of
Re: Maytag Refrigerator Ice Maker Frozen
Our house didn't even have a refrigerator when we bought it.
I was happy about that, actually.
ChrisJ
Re: Bell & Gossett Circulator
The expansion tank is on the system side of the prv which is correct in itself. It should be positioned such that the circulator it pumping away from where it connects to the system.
mattmia2
Re: Professional opinions please
I would like to take full credit @Intplm. However this is the OP's drawing with some modifications. I find that using the original drawings from the OP (any OP) makes it easy for them to understand the minor changes that improve the design.
Re: Insulation for steam pipes in basement
1"wall fiberglass and PVC fitting covers. Buy the thumbtacks with the pvc covers. Thumbtacks have little barbs to hold them in place skip the tape it makes a mess.
Trick: put the thumbtacks in the PVC fitting before you put the fitting on the pipe
Re: Bell & Gossett Circulator
You could have just as easily set that unistrut on the floor in front of the basement wall as in the middle of the room.
mattmia2
Re: Insulation for steam pipes in basement
@dandub1960 with all respect I would rateher leave the pipe bare.
Re: Type K copper pipe
Not sure if anyone mentioned a tracer wire? Anytime we bury plastic pipe we zip tie a tracer wire to it.
MikeL_2
Re: 1/2" NPT to ??? adapter
Call a professional who is licensed to work on and is familiar with gas.
GroundUp
Re: Trane HP condensers delivered to site without circuit boards
Where were these purchased from? Contact them.
pecmsg
Re: Replacing thermostat circuit board in a Taco 006 with a 5 wire fan capacitor?
Your post title implied you were removing the thermostat circuit board and replacing it with a 5 wire fan capacitor ONLY !!!
" I'm adding a relay unit with C wire to enable a smart thermostat, and one way to do it is pull the board from the Taco and replace it with the relay, but I still need a starting cap. "
OK, so what you wrote the board goes away and an unknown relay is added with a 5 wire fan capacitor.
No transformer original or replacement was mentioned. What would you expect a thermostat that was connected to that situation would do ???
I have know idea what your electrical knowledge and skill level is, and what you wrote made little sense to me and apparently others.
BTW (not that it matters) I've repaired and tested many VFDs, from fractional to over 100 HP, I get how the tech works.
I'm still under the impression only you condone what you did and how you did it.
109A_5