A Good Laugh
Comments
-
You can't make this stuff up.
1 -
Be Creative.
The upper one is a towel warmer.
2 -
The rare "double decker" baseboard.
Maybe it's 2 stage bathroom heat 😂.
2 -
A different kind of "upper decker" 😈
All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting
3 -
Dual fuel, one electric, one hydronic. Hide out in the bathroom if the boiler goes down.🏦
Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream1 -
All well and good but did they use the Haydon 750P for corrosion resistance in that location?
I always thought that adding the Letter P to the 750 model number was a significant statement for that brand of baseboard. Lets you know exactly why you should use it in the bathroom!
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
2 -
It probably means plated.
Yes, I'm excellent at parties!
Single pipe 392sqft system with an EG-40 rated for 325sqft and it's silent and balanced at all times.
2 -
Disagree….. it means P
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
2 -
Metallic Pea like the Family Truckster?
Single pipe 392sqft system with an EG-40 rated for 325sqft and it's silent and balanced at all times.
4 -
Now thats good design!
1 -
i did that for like 5' at the end in my shop in the basement because the heat loss said i needed that much more that I had wall. what I didn't know at that time was that the higher entering temp lowers the output of the upper section. so i guess i needed to continue it another 5' around the corner…
1 -
Next time do it this way…. same air inlet temperature so the same output.
You can tell that I have nothing better to do with this last illustration.
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
3 -
That's just there for more target practice.
3 -
Looks like Sterling Kompak on top the bottom one looks like a different brand, so they are all mangled up Not only did they double it up he piped the fin tube without checking how the covers fit.
0 -
Was that Columbus, Ohio?
0 -
-
0 -
For what's it's worth, I have a baseboard cabinet in the kitchen where they JAMMED in two 3/4" finned elements in parallel to get more heat. The fins are mashed up a bit and don't know if the air flow through this mess actually adds more heat that a single high output section installed correctly.
0
Categories
- All Categories
- 87.5K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 61 Biomass
- 431 Carbon Monoxide Awareness
- 124 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.9K Gas Heating
- 118 Geothermal
- 170 Indoor-Air Quality
- 3.8K Oil Heating
- 78 Pipe Deterioration
- 1K Plumbing
- 6.6K Radiant Heating
- 395 Solar
- 15.9K Strictly Steam
- 3.5K Thermostats and Controls
- 57 Water Quality
- 51 Industry Classes
- 51 Job Opportunities
- 18 Recall Announcements