Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!

Furnace not working

simp50
simp50 Member Posts: 2
in Gas Heating
Combustion air inducer runs continuously when power is on and thermostat off on a Lennox 80 uhh furnace

Comments

  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 18,770
    Disconnect the thermostat wires at the furnace and see if the inducer shuts down. If it does t stat or tstat wiring is defective.

    If it does shut down the control board or relay taht starts the inducer is probably defective
  • ratio
    ratio Member Posts: 4,149
    Open limit?
    SuperTech
  • SuperTech
    SuperTech Member Posts: 2,625
    ratio said:
    Open limit?
    That would be my first thought.  Open rollout or limit switch.  The control board on the furnace should indicate a fault code by flashing the LED, that should point you in the direction of the cause of your problem. 
  • HVACNUT
    HVACNUT Member Posts: 7,067
    Inducer fan relay is stuck or shorted closed. Need a new circuit board. 
  • mikeapolis
    mikeapolis Member Posts: 48
    Does switching the T-stat to "fan on" turn the blower on?
  • simp50
    simp50 Member Posts: 2
    Thanks guys looks like I’m gonna have to get a control board 
  • Ironman
    Ironman Member Posts: 7,771
    It's probably not the board, but an open limit or flame rollout switch.
    Bob Boan
    You can choose to do what you want, but you cannot choose the consequences.
  • Seabee5701
    Seabee5701 Member Posts: 19
    Bad ignitor.....

Categories