Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!
Evaporator Connection Not What Expected
Options
BigRob
Member Posts: 332
Hi all, I picked up an evaporator for a wine room application and the TXV connection is not what I expected and I’m confused. Is this a SAE connector and why is it sealed? There are also cotter-like pins around the perimeter. Do I cut this off?




0
Comments
-
Seems like you have half the system
There was an error rendering this rich post.
0 -
I never saw one of those. Maybe some type of Chatliff connector0
-
-
Looks like some sort of quick connect precharged system.0
-
Before you cut it off, make sure the tubing is a metal and size you can connect to.0
-
Standard Flair connection. The holes are to alloy moisture to drain rather then break the flair nut.I prefer remove them and use Stay Brite #8 to solder in the x-valve.0
-
Ah, maybe it's a metal dust cap inside a flare nut?0
-
-
Thanks for all your suggestions. I’ll give it a gentle pry and report back.0
Categories
- All Categories
- 87.5K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 59 Biomass
- 429 Carbon Monoxide Awareness
- 124 Chimneys & Flues
- 2.2K Domestic Hot Water
- 5.9K Gas Heating
- 119 Geothermal
- 168 Indoor-Air Quality
- 3.8K Oil Heating
- 78 Pipe Deterioration
- 1K Plumbing
- 6.6K Radiant Heating
- 394 Solar
- 15.9K Strictly Steam
- 3.5K Thermostats and Controls
- 56 Water Quality
- 50 Industry Classes
- 50 Job Opportunities
- 18 Recall Announcements


