Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
New To Board
Options
BDR529
Member Posts: 285
in Oil Heating
Comments
-
welcome!!0
-
-
Welcome, @BDR529 ! Tell us a bit about yourself- where you're located, what kinds of units you generally work on, etc.All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting0 -
Welcome aboard.Bob Boan
You can choose to do what you want, but you cannot choose the consequences.0 -
I'm in the New England area. Oil fired equiptment only and some waste oil. Waste makes for interesting topics in itself..
Been inheriting alot of Buderus lately. Got a another LoNox yesterday, so underated!
Slat/fin Eutectic for direct vent was very nice as well. To bad no one picked up that deal with Dedetrich after the run with Slan/Fin.
Also got a Burnham MPO IQ with a NX burner (Mica widows, direct vent) that has been a very good unit other than getting the Hago for it.
On the fence on that might be my choice to replace the defunct Eutectic.0 -
Oh, and the plethora of single pass pinners. Sitting across from me in the office is a 2-nozzel Winkler LP.0
-
-
Hour west of Boston.0
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 73 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 61 Pipe Deterioration
- 884 Plumbing
- 5.9K Radiant Heating
- 376 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 59 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements