Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
New To Board

BDR529
Member Posts: 340
in Oil Heating
Comments
-
welcome!!0
-
-
Welcome, @BDR529 ! Tell us a bit about yourself- where you're located, what kinds of units you generally work on, etc.All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting0 -
Welcome aboard.Bob Boan
You can choose to do what you want, but you cannot choose the consequences.0 -
I'm in the New England area. Oil fired equiptment only and some waste oil. Waste makes for interesting topics in itself..
Been inheriting alot of Buderus lately. Got a another LoNox yesterday, so underated!
Slat/fin Eutectic for direct vent was very nice as well. To bad no one picked up that deal with Dedetrich after the run with Slan/Fin.
Also got a Burnham MPO IQ with a NX burner (Mica widows, direct vent) that has been a very good unit other than getting the Hago for it.
On the fence on that might be my choice to replace the defunct Eutectic.0 -
Oh, and the plethora of single pass pinners. Sitting across from me in the office is a 2-nozzel Winkler LP.0
-
-
Hour west of Boston.0
Categories
- All Categories
- 86.9K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 57 Biomass
- 425 Carbon Monoxide Awareness
- 109 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.7K Gas Heating
- 105 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 70 Pipe Deterioration
- 977 Plumbing
- 6.3K Radiant Heating
- 387 Solar
- 15.4K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements