Can you please critique this boiler setup that was installed in my house two wks ago
Comments
-
ok so here are the updates that were finally done on Monday
0 -
-
That plugged Tee is gonna hold water which could be an issue. Have them rotate it so that the bull is pointing upward and it will be okay.
Bob Boan
You can choose to do what you want, but you cannot choose the consequences.
4 -
will do thanks
0 -
Every fitting in the header is going to hold some water id leave the tee alone. As long as the water doesn't restrict the flow it shouldn't matter.
But I am curious why it's there?
Single pipe 392sqft system with an EG-40 rated for 325sqft and it's silent and balanced at all times.
2 -
Why wasn't the second riser tapping used?
0 -
They did the cheapest correction possible.
A better approach would have been to reverse the two connections to the Tees so that both risers were used.
Bob Boan
You can choose to do what you want, but you cannot choose the consequences.0 -
It looks like they enlarged the single supply. It might even be as per manufacturer specification. But even if it's not, it's fine.
NJ Steam Homeowner.
See my sight glass boiler videos: https://bit.ly/3sZW1el1
Categories
- All Categories
- 87.9K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 60 Biomass
- 430 Carbon Monoxide Awareness
- 134 Chimneys & Flues
- 2.2K Domestic Hot Water
- 6K Gas Heating
- 124 Geothermal
- 170 Indoor-Air Quality
- 3.9K Oil Heating
- 80 Pipe Deterioration
- 1.1K Plumbing
- 6.7K Radiant Heating
- 397 Solar
- 16.1K Strictly Steam
- 3.5K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 52 Job Opportunities
- 18 Recall Announcements