Additional Low Water Cutoff
Comments
-
Ken Resnick and Lance for Rathe Sales showcased that new Hydrolevel LWCO at a recent Continuing Ed Training...can't wait to try it. Mad Dog
0 -
Must be some type of light sensor.
0 -
Why ? With this kit, its looks like just a chamber like a mini M&M #67 without the float (piped the same way as the 67) and it's just a probe type LWCO. First item below "Cast Iron Hub Assembly" Has nothing to do with the sight glass except it is a convenient place to put it like the 67.
National - U.S. Gas Boiler 45+ Years Old
Steam 300 SQ. FT. - EDR 347
One Pipe System0 -
I think @EBEBRATT-Ed was referring to this one which does seem to use an optic sensor on the gauge glass itself
NJ Steam Homeowner.
See my sight glass boiler videos: https://bit.ly/3sZW1el0 -
yes to the optic sensor.
As far as hydrolevel goes they have had the parts available to mount a probe type on a gauge glass for years. It just took some searching in their catalog to find it.
0 -
As far as the picture I posted above from another older thread of the sensor attached directly to the sight glass;
Proximity Switch
Omron E2K-C25MY2
Capacitive Proximity Switch
200mA MaxNational - U.S. Gas Boiler 45+ Years Old
Steam 300 SQ. FT. - EDR 347
One Pipe System0
Categories
- All Categories
- 87.6K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 59 Biomass
- 430 Carbon Monoxide Awareness
- 124 Chimneys & Flues
- 2.2K Domestic Hot Water
- 5.9K Gas Heating
- 120 Geothermal
- 168 Indoor-Air Quality
- 3.8K Oil Heating
- 78 Pipe Deterioration
- 1K Plumbing
- 6.6K Radiant Heating
- 394 Solar
- 16K Strictly Steam
- 3.5K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 51 Job Opportunities
- 18 Recall Announcements




