Need help with wall heater

hello my wall heater just started acting up. I jumped the wires at the thermostat and no luck replaced the thermopile and still didn’t work. I jumped the terminals at the regulator and she fires up. I’ve checked all the electrical connections and everything looks good. What am I missing ?
Comments
-
A limit control
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
0 -
also when I relight pilot light it will fire up for a split second then shut off
0 -
Thanks in advance for any input0 -
Follow the blue wires thru the heater. they will go to a limit control or maybe a series of limit controls. one of the limit controls may be a manual reset control. It may look like this
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
0 -
Thx Ed. That reset was in the up position I pushed it down and the stove still doesn’t operate. Attached is photo of my pilot. Looks as strong as it normally is o I don’t believe it a clogged pilot.
0 -
disregard thank you Ed that was the problem! Very much appreciated my cold family thanks you!
0 -
-
where is the filter at?
0 -
Does this furnace have a fan to circulate the warm air, or does it operate by gravity?
If it's gravity, there is no filter. If there is a fan, the filter will be between the return air intake and the fan.
If you post a photo with the cover off, we can probably help you find it.—
Bburd0
Categories
- All Categories
- 86.8K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 56 Biomass
- 425 Carbon Monoxide Awareness
- 109 Chimneys & Flues
- 2K Domestic Hot Water
- 5.6K Gas Heating
- 105 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 69 Pipe Deterioration
- 965 Plumbing
- 6.3K Radiant Heating
- 385 Solar
- 15.3K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 47 Job Opportunities
- 18 Recall Announcements