Electrical - plug lock?
Does anyone make some kind of listed lock or strap to keep plugs from being removed from receptacles? For example sump pumps etc.
I know there's twist lock plugs but id rather not get into cutting off molded plugs to add a different plug on a cord.
Comments
-
Not allowed……code
Hard wire makes it difficult.
0 -
It is the disconnecting means. I'd go with the twistloc.
David's concerns are bout cheap hardware store plugs on zip cord. The type of clamp and termination that a twistloc plug uses makes it very unlikely that the cord would pull out of the plug.
0 -
Although if you put a switch before the receptacle that I think would solve the disconnecting means part.
0 -
hang a sign nearby: DO NOT UNPLUG
0 -
-
yes
In my area 6’ line of sight.
0 -
-
-
You could put this type of cover on it and loop the cord in such a way that it tends to pull the plug in rather than out under the cover:
0 -
You can get a lockable in-use cover:
0 -
-
-
wondering same thing Chris. Thought I missed an inside joke.
0 -
😁
0 -
What @hot_rod posted should work if it is listed but I would put a switch in front of it. Or a twist lock.
0 -
I bet it is not listed for obvious reasons. It also says contact us for chargers not shown here which would imply they definitely didn't put it through the listing process.
I strongly suspect that they are completely oblivious to the fact that it needs to be listed.
0
Categories
- All Categories
- 86.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 99 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 913 Plumbing
- 6K Radiant Heating
- 380 Solar
- 14.8K Strictly Steam
- 3.3K Thermostats and Controls
- 53 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements