Is Baseray considered a radiator or a fin tube?
I'm aware that mixing copper fin tube and CI radiators on a zone is a no-no. Question is, does CI Baseray fall under the same "class" as CI radiators or fin tube? It's cast iron, but has fins (???)
Comments
-
Its radiation. Fine to mix That w/ CI rads.
Its cast iron so the mass of it heats up slower and releases slower.
Copper fin tube has no mass.
2 -
The challenge is copper heats up and cools down five times faster than cast-iron. That creates a huge temperature imbalance when the two metals are on the same zone.
Retired and loving it.
7 -
Is Baseray considered a radiator or a fin tube?
Radiator
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
0 -
Base(board) Ray(diator)
Slant Fin Galaxy GG100(1986) , 2 zone hot water baseboard, T87 Honeywell thermostats.1 -
It's both a radiator and finn tube but acts more like a CI radiator due to it's mass.
2 -
Great. Thanks everyone!
Trying to squeeze the best out of a Weil-McLain JB-5 running a 1912 1 pipe system.0
Categories
- All Categories
- 87.2K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 59 Biomass
- 427 Carbon Monoxide Awareness
- 117 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.7K Gas Heating
- 111 Geothermal
- 163 Indoor-Air Quality
- 3.7K Oil Heating
- 72 Pipe Deterioration
- 1K Plumbing
- 6.4K Radiant Heating
- 393 Solar
- 15.5K Strictly Steam
- 3.4K Thermostats and Controls
- 55 Water Quality
- 51 Industry Classes
- 49 Job Opportunities
- 18 Recall Announcements