Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Leak

oldburner
oldburner Member Posts: 1
edited February 2021 in THE MAIN WALL
Hot side coming out of boiler 
hot water ,,,
has a leak 
can I use a shark bite fitting 
there instead of sweating 
in copper with out any problems ? 
thx

Comments

  • MrScott
    MrScott Member Posts: 15
    Pictures?
  • Jamie Hall
    Jamie Hall Member Posts: 23,170
    Um... only until you get around to repairing it properly.
    Br. Jamie, osb
    Building superintendent/caretaker, 7200 sq. ft. historic house museum with dependencies in New England
    mattmia2
  • oldburner
    oldburner Member Posts: 1
    MrScott said:
    Pictures?

    can’t seem to post any pictures 

  • oldburner
    oldburner Member Posts: 1

  • JUGHNE
    JUGHNE Member Posts: 11,042
    edited February 2021
    Hold your new fitting next to the old one, not an exact line up.
    You need to have an offset on the vertical pipe.
    The Sharkbite will only accept a bare pipe and not the end that still has the fitting soldered on it.

    What are the temp limitations of the Sharkbite fittings?

    You have to drain the boiler in any case, unsolder or cut and add length and offset.
    So soldering would be the easiest route, IMO.
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 15,455
    I don't think you need to drain the boiler, looks like a tankless heater connection.

    You might need a short piece of copper and a shark bite coupling.

    I never used shark bite, I would solder it
  • oldburner
    oldburner Member Posts: 1


    Fixed :) 
    Grallert