Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Question about thermostat wiring on new boiler

Options
codyr
codyr Member Posts: 12
in Thermostats and Controls
I’m installing a new Buderus boiler for radiant floor heat and was about to hook up the red thermostat wire to “R” and white wire to “W” but noticed that there is a factory installed jumper between both contacts. Do I just leave this jumper in place and proceed with the wiring connections? Thanks! 

Comments

  • EdTheHeaterMan
    EdTheHeaterMan Member Posts: 7,852
    Options
    That jumper will make the thermostat irrelevant if that is where you are supposed to connect it. What do the directions say?

    Edward Young Retired

    After you make that expensive repair and you still have the same problem, What will you check next?

  • codyr
    codyr Member Posts: 12
    Options
    EdTheHeaterMan said:
    That jumper will make the thermostat irrelevant if that is where you are supposed to connect it. What do the directions say?
    There is nothing in the directions about connecting the thermostat wires. All it says is “see wiring diagram.” There’s a picture of the jumper in place in one of the manual diagrams which confused me more. 
  • STEVEusaPA
    STEVEusaPA Member Posts: 6,505
    Options
    What does it say where there is a triangle with a 2 in it?

    There was an error rendering this rich post.

  • codyr
    codyr Member Posts: 12
    edited February 2021
    Options
    STEVEusaPA said:
    What does it say where there is a triangle with a 2 in it?

    The triangle with the 2 is the thermostat wires, per the instruction diagram 

Categories