Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Question about thermostat wiring on new boiler
Options
codyr
Member Posts: 12
I’m installing a new Buderus boiler for radiant floor heat and was about to hook up the red thermostat wire to “R” and white wire to “W” but noticed that there is a factory installed jumper between both contacts. Do I just leave this jumper in place and proceed with the wiring connections? Thanks!
0
Comments
-
That jumper will make the thermostat irrelevant if that is where you are supposed to connect it. What do the directions say?Edward F Young. Retired HVAC ContractorSpecialized in Residential Oil Burner and Hydronics0
-
EdTheHeaterMan said:That jumper will make the thermostat irrelevant if that is where you are supposed to connect it. What do the directions say?0
-
What does it say where there is a triangle with a 2 in it?steve0
-
STEVEusaPA said:What does it say where there is a triangle with a 2 in it?0
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 73 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 61 Pipe Deterioration
- 884 Plumbing
- 5.9K Radiant Heating
- 376 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 59 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements