Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Heating Return Manifold Question

JMGotts
JMGotts Member Posts: 10
in THE MAIN WALL
My son sent me a pic of his configuration while troubleshooting a zone issue. On a 4 zone config with a common return manifold, there is an extra zone valve installed in the main feed return to the boiler. If you picture a kitchen fork standing upright, the 4 zones would be the tines, the handle the common return. I don’t understand that zones purpose and additionally, its installed with the valve facing the return flow direction. The other 4 are opposite direction.
Give me a clue please.
Interpret how I say it, not how you think it.

Comments

  • Ironman
    Ironman Member Posts: 7,717
    Got any pics?

    What you're describing makes no sense to me either.
    Bob Boan
    You can choose to do what you want, but you cannot choose the consequences.
  • Zman
    Zman Member Posts: 7,611
    Could you post the photo he sent?
    "If you can't explain it simply, you don't understand it well enough"
    Albert Einstein
  • JMGotts
    JMGotts Member Posts: 10

    Interpret how I say it, not how you think it.
  • mattmia2
    mattmia2 Member Posts: 12,676
    I think that is the zone valve for the indirect water heater but i can't see where it goes from that pic.

    I have some questions about pitch and clearances on that vent.
    rick in AlaskaSuperTechIronman
  • JMGotts
    JMGotts Member Posts: 10
    Haven’t seen it first hand yet.
    Interpret how I say it, not how you think it.

Categories