Is there a fix for my rad screw up?

Options
OhioRuss
OhioRuss Posts: 29
in THE MAIN WALL
I cut into the thread of a cast iron radiator taking out the spud. Anyone have suggestions? It’s 1 1/4” and I was going to put a 1 1/4” - 1/2” reducing bushing. . Thank you so much. I’m such an idiot.

Comments

  • Intplm.
    Intplm. Posts: 3,156

    Have used this over the years. If you do enough of this type of work, and cut into the threads, one is bound to have to use this product.
    HVACNUT
  • OhioRuss
    OhioRuss Posts: 29
    Great. Thx
  • wesPA
    wesPA Posts: 41
    2nd on the x-pando! I have used it many times for spuds. Just make sure you allow the proper cure time.

Categories