Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Is there a fix for my rad screw up?
Options
OhioRuss
Member Posts: 29
I cut into the thread of a cast iron radiator taking out the spud. Anyone have suggestions? It’s 1 1/4” and I was going to put a 1 1/4” - 1/2” reducing bushing. . Thank you so much. I’m such an idiot.
0
Comments
-
-
Great. Thx0
-
2nd on the x-pando! I have used it many times for spuds. Just make sure you allow the proper cure time.0
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 73 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 61 Pipe Deterioration
- 884 Plumbing
- 5.9K Radiant Heating
- 376 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 59 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements