Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Is there a fix for my rad screw up?
Options

OhioRuss
Member Posts: 29
I cut into the thread of a cast iron radiator taking out the spud. Anyone have suggestions? It’s 1 1/4” and I was going to put a 1 1/4” - 1/2” reducing bushing.
. Thank you so much. I’m such an idiot.

0
Comments
-
-
Great. Thx0
-
2nd on the x-pando! I have used it many times for spuds. Just make sure you allow the proper cure time.0
Categories
- All Categories
- 87K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 57 Biomass
- 425 Carbon Monoxide Awareness
- 113 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.7K Gas Heating
- 106 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 70 Pipe Deterioration
- 981 Plumbing
- 6.3K Radiant Heating
- 388 Solar
- 15.4K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 48 Job Opportunities
- 18 Recall Announcements