Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Old oil to gas conversion boiler with Economite E20.
Options
Oil_to_gas_1
Member Posts: 1
I hope someone can assist. I have a very old boiler which used to burn oil but was converted to gas. It has an Economite E-20 gas conversion motor that was installed long ago. It broke! I am able to get a new Economite E 20 motor but can't find a motor bracket that fits perfectly. The ones we have found seem to sit too high. There are nuts and bolts on top of the E-20. Are those supposed to be removed? I don't understand why the parts don't fit. Help please.
0
Comments
-
The E20 is not my favorite burner. Most installations of this burner that I've encountered were not done properly- lots of flame impingement, poor combustion etc.
What make and model is the boiler?All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting1 -
Time for an upgrade, if the boiler doesn't have a steel chamber.
Post pics.0 -
the bolts are welded to motor rubber discs with brass sleaves suport the motor wire clips hold the rubber nuts not needed0
-
Get in touch with me at 401-437-0557 I have all kinds of information on the E-20. I have installed thousands of them in the past.0
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 73 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 129 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 61 Pipe Deterioration
- 884 Plumbing
- 5.9K Radiant Heating
- 376 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 59 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements