CT400 Ridgid Pro Press gun, recalibration and maintenance
Hi guys, wondering if there is any recalibration and maintenance procedures in a PDF somewhere for the CT400. I know the tool is obsolete but I can find identical parts on my own such as orings, seals, etc online. I’m handy in that aspect.
just wanted to know how to reset the counter and if there is any shop manual with parts list and diagrams.
Comments
-
here is the manual
I think it needs to go to a Rigid service center for recalibration
Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream0 -
I had one of those where I worked . It was the first PP gun we ever bought. Must have been around 2002?
It was heavy and big (especially when crimping 2 1/2"-4" and tough to get in tight spaces and no batteries to fool with. When it crimped it was a no doubt crimp. I liked it for that reason. No grunting like the battery tools.
0 -
My guess would be Ridgid won't provide you the info you need to reset the machine. If you bring it in they may tell you to buy a new one.
0 -
All of what you ask can be done by a DIY'er. The calibration, however, must be done by a Ridgid repair center.
0
Categories
- All Categories
- 87.9K THE MAIN WALL
- 3.3K A-C, Heat Pumps & Refrigeration
- 60 Biomass
- 430 Carbon Monoxide Awareness
- 134 Chimneys & Flues
- 2.2K Domestic Hot Water
- 6K Gas Heating
- 124 Geothermal
- 170 Indoor-Air Quality
- 3.9K Oil Heating
- 80 Pipe Deterioration
- 1.1K Plumbing
- 6.7K Radiant Heating
- 397 Solar
- 16.1K Strictly Steam
- 3.5K Thermostats and Controls
- 56 Water Quality
- 51 Industry Classes
- 52 Job Opportunities
- 18 Recall Announcements