Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

VXT-24 Water Heater

PaulLandon23
PaulLandon23 Member Posts: 2
in Thermostats and Controls

Hello


I recently purchased the VXT-24 automatic water feeder. I am about to install it and notice an unusual orientation of the valve that came floating inside the enclosure. In the pictures that I’ve seen it shows the two electrical terminals jetting out to the left if you’re looking straight at it. If I were to install it where the stud of the screw the valve, it shows it covering the LED display. (Picture enclose)

did this feeder come to me broken or wrong? Any input is appreciated


Paul


IMG_0653.png
IMG_0654.jpeg



Comments

  • Jamie Hall
    Jamie Hall Member Posts: 24,696

    Can you rotate that green plastic piece with the wiring terminals in the metal bracket? Should be possible — considering that I see 7 possible slots for the index on the plastic piece.

    Br. Jamie, osb
    Building superintendent/caretaker, 7200 sq. ft. historic house museum with dependencies in New England
  • PaulLandon23
    PaulLandon23 Member Posts: 2

    i suppose I could but I’m not sure how to. It seems molded

  • Larry Weingarten
    Larry Weingarten Member Posts: 3,576

    Hi, I see what looks like the end of a bolt in the center of the plated metal piece. Can you get to the back side of it to see if you have a bolt head there?

    Yours, Larry

  • Steamhead
    Steamhead Member Posts: 17,358
    https://forum.heatinghelp.com/discussion/comment/1814129#Comment_1814129

    That left-side orientation is correct.

    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting

Categories