Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Tekmar 367 zone always calling for heat

Options
mbehrens
mbehrens Member Posts: 3
in Radiant Heating
I have a 18 year old radiant system with a Tekmar 367 controller. Worked perfectly until last season when I noticed Zone 1 seemed too warm. This season I see that zone 1 continually calls for heat, even when both wires from the RTU are disconnected from the controller. In test mode, it lights up in this sequence: Pump-6-5-4-3-1 (stays lit) then 2 lights up along with 1. There are no flashing lights or other signs of an error. When either wire from zone 2 RTU is also disconnected from the controller, zone 1 finally stops calling for heat.
Anyone see an easy fix, or just time for a new controller?

Welcome

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Comments

  • HVACNUT
    HVACNUT Member Posts: 6,869
    Is this part correct?
  • mbehrens
    mbehrens Member Posts: 3
    Yes. Six RTU's controlling six one-stage valves. Zone 1 used to work normally and no changes have been made to DIP switches or wiring.
  • mbehrens
    mbehrens Member Posts: 3
    To clarify a little more, if either wire for zone 2 RTU is disconnected, but zone 1 RTU wires are both connected normally, zone 1 stops calling for heat, even if I put a jumper on the zone 1 connections and bypass the RTU entirely. And when I go thru test mode with 1 wire disconnected from the zone 2 RTU but all other wires connected, I get pump-6-5-4-3. 1 and 2 don't light up in this test, and again no other errors.

Welcome

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Welcome

It looks like you're new here. Sign in or register to get started.
Sign In
Register

Quick Links

Categories