Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Ridgid ProPress service.
PC7060
Member Posts: 1,624
I’ve got a Ridgid RP 241 compact press tool which typically works flawlessly with the exception of 3/4” fitting.
The jaws took a beating on a job a couple of years ago and have never been the same. Before I pop for a new set I’m considering sending both the tool and the jaws off for service / calibration. Has anyone on the site sent their Press-tool off and if so where did you get it serviced?
0
Comments
-
Where are you located?
These guys are great, and have great prices on tools. I got my 340 for over $500 less than I could find in any store or online.
I’d call first. They are pretty easy to talk to on the phone. Not the usual grouchy guy at the supply house.
https://www.jekk-tools.com/tool-repair2.htmlThere was an error rendering this rich post.
1 -
I purchased mine through FW Webb. They also arrange the service. No issues. Happy to do it.0
-
The repair service on my ProPress was quoted so high I found one with a broken case on ebay and switched the guts.1
Categories
- All Categories
- 86.8K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 57 Biomass
- 425 Carbon Monoxide Awareness
- 109 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.6K Gas Heating
- 105 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 70 Pipe Deterioration
- 966 Plumbing
- 6.3K Radiant Heating
- 385 Solar
- 15.3K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 47 Job Opportunities
- 18 Recall Announcements