Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Ridgid ProPress service.
PC7060
Member Posts: 1,279
I’ve got a Ridgid RP 241 compact press tool which typically works flawlessly with the exception of 3/4” fitting.
The jaws took a beating on a job a couple of years ago and have never been the same. Before I pop for a new set I’m considering sending both the tool and the jaws off for service / calibration. Has anyone on the site sent their Press-tool off and if so where did you get it serviced?
0
Comments
-
Where are you located?
These guys are great, and have great prices on tools. I got my 340 for over $500 less than I could find in any store or online.
I’d call first. They are pretty easy to talk to on the phone. Not the usual grouchy guy at the supply house.
https://www.jekk-tools.com/tool-repair2.htmlThere was an error rendering this rich post.
1 -
I purchased mine through FW Webb. They also arrange the service. No issues. Happy to do it.0
-
Categories
- All Categories
- 85.9K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 420 Carbon Monoxide Awareness
- 78 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.3K Gas Heating
- 94 Geothermal
- 154 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 886 Plumbing
- 5.9K Radiant Heating
- 378 Solar
- 14.6K Strictly Steam
- 3.2K Thermostats and Controls
- 51 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements