Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Burnham Series 2 Where to mount flame rollout switch?
Options

capouch
Member Posts: 19
I have a Series 2 Model 209 from which an unknown person in the past removed and hot-wired around a blown flame rollout switch. I found the switch and mounting bracket, and have purchased a new switch. The burners were a mess and I cleaned them; I've observed it for hours and the flames look really good.
What I haven't done, yet, is figure out just where the switch mounts. The manual page shows some arrows but not in enough detail for me to see just where it is supposed to go, and I don't see an obvious place after a fair bit of careful scrutiny of the burner area.
What I haven't done, yet, is figure out just where the switch mounts. The manual page shows some arrows but not in enough detail for me to see just where it is supposed to go, and I don't see an obvious place after a fair bit of careful scrutiny of the burner area.
0
Comments
-
It looks like it mounts to the burner door, behind the gas valve.
It would be wise to have a combustion test done after its complete.0 -
Contact John "JohnNY" Cataneo, NYC Master Plumber, Lic 1784
Consulting & Troubleshooting
Heating in NYC or NJ.
Classes0
Categories
- All Categories
- 87K THE MAIN WALL
- 3.2K A-C, Heat Pumps & Refrigeration
- 57 Biomass
- 425 Carbon Monoxide Awareness
- 112 Chimneys & Flues
- 2.1K Domestic Hot Water
- 5.7K Gas Heating
- 106 Geothermal
- 160 Indoor-Air Quality
- 3.6K Oil Heating
- 70 Pipe Deterioration
- 980 Plumbing
- 6.3K Radiant Heating
- 388 Solar
- 15.4K Strictly Steam
- 3.4K Thermostats and Controls
- 54 Water Quality
- 44 Industry Classes
- 48 Job Opportunities
- 18 Recall Announcements