Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Oil Burner Not Working after fill but works now. Question
Options
ImYoungxD
Member Posts: 130
I got my tank filled last week when the gauge was between 1/8 - 1/4. I added oil treatment solution before they filled it. 2-3 days later, the beckett burner blinks red. I pressed the button, 5-10 minutes later, it goes dead again. I was thinking the filter was clogged but instead, I played with the valve that lets the oil in. I heard a gurgle in the oil line and now the boiler works fine.
What just happened? Was there air in the line or did I just pushed sludge to the filter?
What just happened? Was there air in the line or did I just pushed sludge to the filter?
0
Comments
-
Try not letting the tank get so low before filling which stirs up sludge. I would check the filter, pump strainer and nozzle.
You could be running but not burning properly0 -
The firomatic valve? Is the stem up?
I dont see why the driver would close a valve.0 -
Could be any of the above or none of the above and just a coincidence and another issue.
There was an error rendering this rich post.
0 -
The old defective oil valves that stripped, are still out there. If it was airbound,you may or may not get away without bleeding,unless it's a two pipe.0
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 49 Biomass
- 418 Carbon Monoxide Awareness
- 72 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 160 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 848 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 50 Water Quality
- 38 Industry Classes
- 47 Job Opportunities
- 15 Recall Announcements