Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Furnace won't light off
Options
happysenior
Member Posts: 3
in Gas Heating
My S8610U module will not give my gas valve 24vac to.open the gas to the burners ? Pilot on.
0
Comments
-
Need some more information. Pictures would help.
D0 -
its on a coleman mobilehome furnance #7600 that has a new honeywell pilot retrofit kit Y8610U....Just installed a new module,as one I got with kit failed. It worked good for a week and just quit.😪it works for a few days,then quits.😿
Furnace is over 30 Yrs old.! Should I take burner out and clean good ? Just put in new blower motor.pilot light works good...0 -
Very possible you may have 1: bad heat exchanger or 2: Rusted chimney vent and intake piping.
Does it light the burner and then a few seconds later flame goes out?
D0
Categories
- All Categories
- 85.2K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 55 Biomass
- 424 Carbon Monoxide Awareness
- 73 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 130 Geothermal
- 160 Indoor-Air Quality
- 3.3K Oil Heating
- 61 Pipe Deterioration
- 885 Plumbing
- 5.9K Radiant Heating
- 376 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 59 Water Quality
- 49 Industry Classes
- 89 Job Opportunities
- 28 Recall Announcements