Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!

Oil burner

Options
unclejohn
unclejohn Member Posts: 1,833
in Gas Heating
Anyone know how this control resets. Honeywell R7997 B 1021 My friend say the green light is blinking and has been all day. Supposed to wait 60 sec and retry. Dosen't say haw many retry's

Comments

  • unclejohn
    unclejohn Member Posts: 1,833
    He found the reset and bleed it and all is well until the next time he runs out of oil.
  • HVACNUT
    HVACNUT Member Posts: 7,207
    I never heard of that model so I looked it up. I never knew HW made an integrated primary.
    When the Carlin EZ came out, they used a similar control by Phaylon but no programming. They didn't last long.
    Bringing the line volt right into the burner housing and making splices in there gets messy.
  • STEVEusaPA
    STEVEusaPA Member Posts: 6,505
    @HVACNUT Bryant used them with their furnaces, for one. Actually the wiring isn't that bad. Usually the voltage comes from the board in the blower compartment. But that control, a little hard to find, is pricey.

    There was an error rendering this rich post.

Categories