Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Oil burner

unclejohn
Member Posts: 1,757
in Gas Heating
Anyone know how this control resets. Honeywell R7997 B 1021 My friend say the green light is blinking and has been all day. Supposed to wait 60 sec and retry. Dosen't say haw many retry's
0
Comments
-
He found the reset and bleed it and all is well until the next time he runs out of oil.0
-
I never heard of that model so I looked it up. I never knew HW made an integrated primary.
When the Carlin EZ came out, they used a similar control by Phaylon but no programming. They didn't last long.
Bringing the line volt right into the burner housing and making splices in there gets messy.0 -
@HVACNUT Bryant used them with their furnaces, for one. Actually the wiring isn't that bad. Usually the voltage comes from the board in the blower compartment. But that control, a little hard to find, is pricey.steve0
Categories
- 117.6K All Categories
- 82.8K THE MAIN WALL
- 2.7K A-C, Heat Pumps & Refrigeration
- 43 Biomass
- 403 Carbon Monoxide Awareness
- 8 Chimneys & Flues
- 1.6K Domestic Hot Water
- 4.3K Gas Heating
- 107 Geothermal
- 148 Indoor-Air Quality
- 2.7K Oil Heating
- 45 Pipe Deterioration
- 680 Plumbing
- 4.8K Radiant Heating
- 353 Solar
- 13.3K Strictly Steam
- 2.9K Thermostats and Controls
- 48 Water Quality
- 31 Industry Classes
- 65 Job Opportunities
- 11 Recall Announcements