Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
hydro therm boiler flame keep turning off
Options
lubu726
Member Posts: 3
in Gas Heating
The burner flame keep turn off after couple mins not the pilot light. To turn the flame back on, I need to switch the power on and off and sometime the flame stay lit , most other time i need to do it couple times for it to stay lit. My friend said to change the thermostat and remove the air from the boiler so I did both of that, but the trouble still not resolve. There are 3 zones for my boiler with 3 thermostats. The blue top is for basement, the middle is for my bedroom but both of the thermostats always shut. The bottom is the main zone with the new thermostat I just install to heat the whole house. If anyone can give some tips to what I can do to resolve this issue,
Thank you
0
Comments
-
Seems like it might be a faulty pilot generator or gas valve.
That's an old boiler. Probably hovering about 60% efficient. Think about replacement.
What's with the blue electrical conduit? Is that to code where you're located?0 -
Never notice it when i bought the house 10 years ago. How much would new boiler cost these day ?0
-
Probably just need to pull out the pilot and clean the thermopile and make sure you have a nice blue pilot flame. It really is time to have a pro look at that boiler.0
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 51 Biomass
- 423 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 60 Pipe Deterioration
- 850 Plumbing
- 5.8K Radiant Heating
- 375 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 51 Water Quality
- 38 Industry Classes
- 55 Job Opportunities
- 18 Recall Announcements