Click here to Find a Contractor in your area.
Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.

Anyone have a Ridgid press tool?

hot_rod
hot_rod Member Posts: 14,797
I have a few tongs up for grabs. New or like new.
$40.00 a piece of $110 for all 3 and I'll pay shipping in US.
1" copper and two PAP

Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream

Comments

  • Harvey Ramer
    Harvey Ramer Member Posts: 2,217
    edited November 2017
    What size are the PAP? If they are 1/2" and 3/4" I'll take them if you are willing to split the pile? I don't mind paying for shipping. They should fit the M-18? My megapress jaws are rigid and they fit.

    Or are they the smaller size?

  • hot_rod
    hot_rod Member Posts: 14,797
    1/2 and 3/4" on the PAP. They are listed as compact and fit these tools. I'm not sure if they would fit other drives?

    Bob "hot rod" Rohr
    trainer for Caleffi NA
    Living the hydronic dream
  • Harvey Ramer
    Harvey Ramer Member Posts: 2,217
    The M-18 uses full sized jaws. So I guess they won't fit after all.

Sign In or Register to comment.

Welcome

It looks like you're new here. If you want to get involved, click one of these buttons!