Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Anyone have a Ridgid press tool?
hot_rod
Member Posts: 23,396
I have a few tongs up for grabs. New or like new.
$40.00 a piece of $110 for all 3 and I'll pay shipping in US.
1" copper and two PAP
$40.00 a piece of $110 for all 3 and I'll pay shipping in US.
1" copper and two PAP
Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream
trainer for Caleffi NA
Living the hydronic dream
0
Comments
-
What size are the PAP? If they are 1/2" and 3/4" I'll take them if you are willing to split the pile? I don't mind paying for shipping. They should fit the M-18? My megapress jaws are rigid and they fit.
Or are they the smaller size?0 -
1/2 and 3/4" on the PAP. They are listed as compact and fit these tools. I'm not sure if they would fit other drives?
Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream0 -
The M-18 uses full sized jaws. So I guess they won't fit after all.0
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 917 Plumbing
- 6.1K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements