Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
baseboard ID help
GW
Member Posts: 4,609
It's not petite, could it be Suntemp? I need to cut the baseboard and add two end caps
0
Comments
-
Does it have a hinged damper, that could help narrow down the brand. Looks a bit like early SlantFin, except for the ridge in the cover panel.Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream0 -
it sure looks hinged, the HO took the pic.0
-
Not Slant/Fin. Their larger baseboard is MultiPak 80, here:
http://www.slantfin.com/products/multi-pak-80/
Not current-model Suntemp or Weil-McLain either, doesn't match what appears on their site.
You might end up installing completely new baseboard there.All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting0 -
yes thanks, I just sent her some costs to install some petite. yet iot's about 1/2 shorter and will need someone to nail on some quarter round to cover the gap0
-
Could be Sterling? Lots of that around. Torrco carries it.0
-
Sure looks like Petite 7 to me.
You would know for sure if you pulled the cover off and saw those funky insulators on the fin.0 -
-
Hah you may be right! I didn't even notice the tape wasn't set to bottom of the cap0
Categories
- All Categories
- 84.3K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 417 Carbon Monoxide Awareness
- 44 Chimneys & Flues
- 1.8K Domestic Hot Water
- 4.8K Gas Heating
- 120 Geothermal
- 156 Indoor-Air Quality
- 3.1K Oil Heating
- 57 Pipe Deterioration
- 799 Plumbing
- 5.5K Radiant Heating
- 371 Solar
- 14.1K Strictly Steam
- 3.1K Thermostats and Controls
- 54 Water Quality
- 39 Industry Classes
- 80 Job Opportunities
- 22 Recall Announcements