Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Buderus Mix Stations
Options
Warmfoot2
Member Posts: 3
I installed a couple of Buderus Mix Stations about ten years ago. The 3-Way Mix Valves have seized. Buderus no longer supports the mix stations. Would anyone have any ideas on where to get replacements? I have a hard time believing that Buderus manufactured these units themselves.
0
Comments
-
Ouch, I think you want a rebuild kit before you open the hood. I would think Buderus could look up the supplier of that valve?
Here is a shot of what is inside this older Esbe brand.Bob "hot rod" Rohr
trainer for Caleffi NA
Living the hydronic dream0 -
I think those stations used ESBE valves, so you might be able to get parts or replacements from them.0
-
FYI - Found 3-way valve rebuild kits from Buderus - They order them from Watts. 6-week lead time. The motors have to be purchased from Buderus as well. Very expensive - Found one on Ebay for 1/4 the cost. will have to order the 2nd one from Buderus.
Ernie0 -
I'll update with pictures when I rebuild it as well...
0
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 51 Biomass
- 423 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 850 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 51 Water Quality
- 38 Industry Classes
- 55 Job Opportunities
- 18 Recall Announcements