Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Lochinvar WHN with indirect
Options
Dan C.
Member Posts: 248
Can the indirect be piped as a zone on the Knight WHN085 and still be set up as a priority zone through the boiler control? I have always piped it the way they show it in figure 6-3 of the manual off of the boiler loop. I would like to pipe this one as a zone but only if there is a way to change it in the computer and make it a priority zone.
0
Comments
-
Yuppers
Suggest you read page 63 of the installation manual..Section 10 - DHW..
http://www.lochinvar.com/_linefiles/WH-I-O-Rev%20M.pdfThere was an error rendering this rich post.
0
This discussion has been closed.
Categories
- All Categories
- 85.7K THE MAIN WALL
- 3K A-C, Heat Pumps & Refrigeration
- 49 Biomass
- 418 Carbon Monoxide Awareness
- 71 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.2K Gas Heating
- 92 Geothermal
- 149 Indoor-Air Quality
- 3.2K Oil Heating
- 59 Pipe Deterioration
- 847 Plumbing
- 5.8K Radiant Heating
- 371 Solar
- 14.5K Strictly Steam
- 3.2K Thermostats and Controls
- 50 Water Quality
- 38 Industry Classes
- 47 Job Opportunities
- 15 Recall Announcements