Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Looking for

Options
Tim McElwain
Tim McElwain Member Posts: 4,621
in THE MAIN WALL
someone in the Bergen/Passiac New Jersey area that can install gas power conversion burners.



Contact me at 401-437-0557 or gastc@cox.net

Comments

  • JStar
    JStar Member Posts: 2,752
    Options
    Tim

    I'm sending you my information right now.
  • Tim McElwain
    Tim McElwain Member Posts: 4,621
    Options
    Thanks JStar

    I got it and you should be connecting up with Robert.
  • Tim McElwain
    Tim McElwain Member Posts: 4,621
    Options
    Thanks JStar

    what a great place the WALL is. A caring grandson looking out for his grandmother comes here looking for help. Sends me an e-mail. I answer his questions and also give him a call on the phone.JStar answers this posting goes there today gives a proposal and I think we are now on the way to the installation of a gas power conversion burner on this oil boiler. WOW
  • Steamhead
    Steamhead Member Posts: 16,835
    Options
    Pictures!

    we need pictures!
    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting
  • JStar
    JStar Member Posts: 2,752
    Options
    Amazing stuff

    And this all happened within 24 hours. The Wall really is an incredible place.



    I will most definitely post pictures, and my review of the Carlin burner. The job is set for the first week of September. Pretty standard stuff. The piping is actually all correct, and the boiler was even sized properly!
  • kcopp
    kcopp Member Posts: 4,432
    Options
    yes it is....

    good people who really care about the trade and are willing to help others.
  • JStar
    JStar Member Posts: 2,752
    Options
    Update.

    http://www.facebook.com/media/set/?set=a.380902848645630.84428.353747484694500&type=1



    We did this conversion yesterday. Here is a link to our Facebook page with pictures. The quality is awful, but it gives you the basic idea.



    I have a few issues with the Carlin installation procedure. The flange is a little tricky to keep straight and level when tightening down the set screws. And we'll be installing a union after the gas valve from now on, to make redrilling the orifice a lot easier. It was also annoying to have to remove the gas valve electrical connections just to screw in my manometer fitting. I'll use a short 1/4" nipple next time.



    Otherwise, it's a great little burner. I'm officially converting to Carlin.
This discussion has been closed.

Categories