protecting wood floor from flame?

R. Kalia_6 · September 2005

If you are forced to do copper pipe soldering close to (say) a wooden floor, what do you use to avoid getting burn-marks on the wood? Is there such a thing as asbestos sheet except without the asbestos?

Unknown · September 2005

ProPress ;-) NM

Wallace Radiant Design

To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"

David Sutton_6 · September 2005

Kaowool blanket

any burner shop or surply house has it, or re michaels has a flame barrier pad you can buy...David

Bob Sweet · September 2005

A piece of

single wall flue pipe works well in a jam.

hr · September 2005

This stuff works!

spray it on wood or even paper and hold a torch to it. For a while, anyways

It generally "buys" enough time to solder next to wood.

hot rod

To Learn More About This Professional, Click Here to Visit Their Ad in "Find A Professional"

Mike T., Swampeast MO · September 2005

A piece of fiber-cement siding.

bernie_3 · September 2005

My Dad gave me a piece of 6" x6" flat copper sheet 20 years ago which I still use today. I can screw it to a floor joist (or whatever you want to protect) and have never left a mark

Al Corelli · September 2005

While I cannot say I've never burned a joist or other rough carpentry, I have had very good luck with flooring and moldings by using skills my Grandfather taught me.

If I burned something, he would bash my knuckles with a 10" wrench. I use a correctly adjusted flame, carefully applied. You'd be surprised just where I can squeeze these battered knuckles while holding a torch.

Unknown · September 2005

Yep , the fluepipe

works good , better with an acetylene B tank with a size A-3 Turbo Torch tip .

maxwell · September 2005

I use an old cookie sheet that my wife rejected for whatever reason. Wet rags under it help too if necessary.

I have also used a piece of transite shingle.

protecting wood floor from flame?

Comments

Categories