Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
If our community has helped you, please consider making a contribution to support this website. Thanks!

Cast Iron Baseboard Leak

Options
Bill Parr
Bill Parr Member Posts: 1
in THE MAIN WALL
Still made today is Weil-McClain and Burnham. Neither of which match the job I am looking at. 20-30 years ago there was, I believe US National. Does anybody know if W/M or Burnham push nipples will fit this older heat panel?
Anybody know if parts available? Where?

Comments

  • Unknown
    Unknown
    went down

    I went down to basement and found some national US baseboard raditors.... Took the weil mclain push nipples to check for sizeing... No problem, will works.. Make sure u clean with pipe wire brush and lightly pipe dope the push nipples... Good heating supply or heating shop will have them along u may need to rent the radiator assembly tool to do the job properly..
This discussion has been closed.

Categories