Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Cast Iron Radiator Disassembly
Cold N Mke
Member Posts: 1
I have a crack in a raised seam of a casr iron radiator. I tried JB Weld but the position is bad, and found another crack on an inner section that I can't reach. Any tips on disassembly?
Thanks
Thanks
0
Comments
-
Look here
There is an article in the "Hot Tech Tips" section of this site that deals with this subject.
I have done this a couple of times with success.
http://www.heatinghelp.com/newsletter.cfm?Id=20
Good luck
JimThere was an error rendering this rich post.
0
This discussion has been closed.
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 916 Plumbing
- 6K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements