Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

Tower blow down valve needed

zepfan
zepfan Member Posts: 421
in THE MAIN WALL

I am looking for an alternate electric valve (110 volt) for a blow down line for a cooling tower. We normally use a red hat solenoid valve, diaphragm type. For some reason they tend to leak more easily causing water treatment to be lost from the tower Maybe a ball valve type would be better.

I did not know if anyone knew of ball valve type that is controlled by a 110 volt actuator. 3/4" fpt. thanks to all

Comments

  • Steamhead
    Steamhead Member Posts: 17,603

    Try Belimo.

    All Steamed Up, Inc.
    Towson, MD, USA
    Steam, Vapor & Hot-Water Heating Specialists
    Oil & Gas Burner Service
    Consulting
    hot_rodzepfan
  • EBEBRATT-Ed
    EBEBRATT-Ed Member Posts: 17,174

    Everyone make them. But as @Steamhead mentioned Belimo is one of the most popular.

    zepfan
  • pecmsg
    pecmsg Member Posts: 5,705

    You should have a strainer before that valve.

    Any motorized valve will work.

    Daily makeup water readings should be taken to notice the issue before losing all those chemicals.

    zepfan

Categories