Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Steam coming from the main vent
Comments
-
I was going to use 2 90's .i think they a 3/4 ?. will that be good ??
0 -
-
Can I get away with just putting on a 6-8 in riser ??
0 -
0
-
-
That church has proved once again that you can't fix stupid.
All Steamed Up, Inc.
Towson, MD, USA
Steam, Vapor & Hot-Water Heating Specialists
Oil & Gas Burner Service
Consulting2 -
@delcrossv is saying that using 45° Street elbow at the bottom and a 45° at the top may be better, that way you can have a longer path for any debris or water to travel before it destroys the vent, and any condensate will drain faster.
Edward Young Retired
After you make that expensive repair and you still have the same problem, What will you check next?
2 -
IS there a way to test the pressurtrol after I clean the pigtail ?? thx
0 -
-
Trying to squeeze the best out of a Weil-McLain JB-5 running a 1912 1 pipe system.0
Categories
- All Categories
- 86K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 52 Biomass
- 421 Carbon Monoxide Awareness
- 81 Chimneys & Flues
- 1.9K Domestic Hot Water
- 5.3K Gas Heating
- 96 Geothermal
- 154 Indoor-Air Quality
- 3.3K Oil Heating
- 60 Pipe Deterioration
- 894 Plumbing
- 5.9K Radiant Heating
- 379 Solar
- 14.7K Strictly Steam
- 3.2K Thermostats and Controls
- 52 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements