Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Superheat & subcooling
Servicewiz_3
Member Posts: 58
Any good resources out there for superheat & subcooling measurements?Where should my subcooling Temp./pressure be taken?
0
Comments
-
The best is a good electronic manifold.. Or do you want to know what they are or how to take them ?
There was an error rendering this rich post.
0 -
That’s a broad question, in general too low sH will harm the compressor. Too high will as well yet your ac will be lame, not enough juice
Sub cool- too little. Not enough juice in the system and your gas may flash in the line before it reaches your Evap. Too high means too much juice in the system
You know the basic definition of super heat and sub cool? Just need gauges and a way to measured the temp of the lines. Most every tech uses digital gauges these days, they have K couple clamps and do the math for you0
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 916 Plumbing
- 6K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements