Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
Hot water zone off steam boiler AQUA STAT
BillAllen
Member Posts: 103
Where is the best place to install the L4006 so it reads the best Temps for the hot water zone? I'v done a few of these but no enough to remember where the Aqua stat is located. Thoughts?
0
Comments
-
-
Why there and not the boiler ?
There was an error rendering this rich post.
0 -
LOL. My mistake, Big Ed. Sleepy. Thanks.Retired and loving it.0
-
Thanks for the tip. I take it the Thermometer should be there too?0
-
Big Ed, There are no ports on the steam boiler to install the Aqua stat. FYI.0
-
Thanks for the discussion tips. I am near finished with the boiler but I still have not wired the L4006 I do not know where to tie in the wiring. I have a clue but not certain. Any tips? The boiler is a W/M EG40. HW loop below steam. All good except wiring the aqua stat0
Categories
- All Categories
- 86.3K THE MAIN WALL
- 3.1K A-C, Heat Pumps & Refrigeration
- 53 Biomass
- 422 Carbon Monoxide Awareness
- 90 Chimneys & Flues
- 2K Domestic Hot Water
- 5.4K Gas Heating
- 100 Geothermal
- 156 Indoor-Air Quality
- 3.4K Oil Heating
- 63 Pipe Deterioration
- 916 Plumbing
- 6K Radiant Heating
- 381 Solar
- 14.9K Strictly Steam
- 3.3K Thermostats and Controls
- 54 Water Quality
- 41 Industry Classes
- 47 Job Opportunities
- 17 Recall Announcements