Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.
trouble shooting a gas furnace w/ UT electronics 1018 series control.

pscanlon
Member Posts: 1
in Gas Heating
woke up to no heat this morning. Power went off last night in storm. Reset thermostat to bring heat back on . Control board was buzzing, and getting hot. Got a new control board and have no heat.
0
Comments
-
Can you provide any more information?
type of heat (steam-hot water-hot air)
Make & model of appliance. Was the "board" that was "new" installed correctly?
What happens when a call for heat has been established?
Does anything happen? Does this have an Hot surface igniter or spark. You say the control is getting hot & buzzing. Any additional info will be helpful in figuring it out.
Robert O'Connor/NJ0 -
You may have a bad transformer after a power surge.0
Categories
- 117.4K All Categories
- 82.7K THE MAIN WALL
- 2.7K A-C, Heat Pumps & Refrigeration
- 43 Biomass
- 401 Carbon Monoxide Awareness
- 7 Chimneys & Flues
- 1.6K Domestic Hot Water
- 4.3K Gas Heating
- 106 Geothermal
- 148 Indoor-Air Quality
- 2.7K Oil Heating
- 45 Pipe Deterioration
- 675 Plumbing
- 4.8K Radiant Heating
- 353 Solar
- 13.2K Strictly Steam
- 2.9K Thermostats and Controls
- 47 Water Quality
- 31 Industry Classes
- 64 Job Opportunities
- 11 Recall Announcements