Welcome! Here are the website rules, as well as some tips for using this forum.
Need to contact us? Visit https://heatinghelp.com/contact-us/.
Click here to Find a Contractor in your area.

triangle tube prestige solo 110 boiler

john_117
john_117 Member Posts: 15
in THE MAIN WALL
We have replaced the draft inducers twice in the last 9 years for this boiler. The inducer has fallen apart on both.
anybody see this before?

Comments

  • john_117
    john_117 Member Posts: 15
    sorry the inducer wheel has fallen apart
  • Robert O'Brien
    Robert O'Brien Member Posts: 3,568
    Usually cross contamination
    To learn more about this professional, click here to visit their ad in Find A Contractor.
    kcoppSWEIZman
  • Bob Bona_4
    Bob Bona_4 Member Posts: 2,080
    You mean like this? Solo 175 day before Thanksgiving. What Robert said, or a fluke. Not common.
  • ced48
    ced48 Member Posts: 469
    Does your system cycle on and off a lot?
  • kcopp
    kcopp Member Posts: 4,520
    Lets see a picture(s) of the outside where your vent and intake terminate....
  • kcopp
    kcopp Member Posts: 4,520
    No pix?
    We would love to help...
    kcopp
  • mstrbill
    mstrbill Member Posts: 37
    Mine did the same after 4 years ,just blew apart today , however it does cycle often due to how it is hooked up to a brazed plate hot water heater for domestic and a flow switch , sooooooooooo, i will make changes on my end but TT should use SS for the inducer wouldyathink???
  • kcopp
    kcopp Member Posts: 4,520
    Its a whole lot harder & $$$ to make and balance a SS fan blade vs. a plastic one.
    SWEI
  • mstrbill
    mstrbill Member Posts: 37
    TT boasts about their SS , all of it . the plastic one is more like a sugar wafer , what a piece of #^#^^. for a 3700 $ heater , i disagree with the cost benifits . they even sell the repair kit with a briefcase omg. for 1700 $ with more plastic . so until they improve i will not install anymore solos , just soyano.
  • Zman
    Zman Member Posts: 7,611
    Do you have pictures of your terminations?
    Cross contamination is usually the culprit not the plastic.
    "If you can't explain it simply, you don't understand it well enough"
    Albert Einstein
    kcoppBob Bona_4margsuarez
  • Aaron_in_Maine
    Aaron_in_Maine Member Posts: 315
    edited February 2016
    If the venting is correct you usually don't have a problem. I have solos out there that are 5+ years old without a single issue. I never use a concentric vent no matter what. I would rather use indoor combustion air before a concentric I just don't trust them.

    There was an error rendering this rich post.

    Robert O'Brienkcopp

Categories